1971 Plymouth Cuba Convertible

When this car was brought to us, it was in the process of being restored. We were to replace the quarter panels and trunk floor along with all the inner structure for those areas. The door gaps needed to be adjusted as well.

(Click on the photos to enlarge)

Fred's Fabrication - 1971 Plymouth Cuba Convertible

This shot was taken when the car first arrived.

Fred's Fabrication - 1971 Plymouth Cuba Convertible

The trunk floor had already been removed.

Fred's Fabrication - 1971 Plymouth Cuba Convertible

We repaired the trunk area with an aftermarket pan...

Fred's Fabrication - 1971 Plymouth Cuba Convertible

and rear frame rails.

Fred's Fabrication - 1971 Plymouth Cuba Convertible

We cut the quarter panels off both sides...

Fred's Fabrication - 1971 Plymouth Cuba Convertible

repaired the inner structure...

Fred's Fabrication - 1971 Plymouth Cuba Convertible

and tack welded the quarters in place.

Fred's Fabrication - 1971 Plymouth Cuba Convertible

Before we started cutting the quarters off, the door gaps were too wide.

Fred's Fabrication - 1971 Plymouth Cuba Convertible

In the process of repairing the quarters, we corrected the door gap problem.

Fred's Fabrication - 1971 Plymouth Cuba Convertible

Here's the car after finish welding and grinding, ready for the customer to finish.

Fred's Fabrication - 1971 Plymouth Cuba Convertible

This shot shows the car finished.

Back to top